|
|||||||
| RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections. |
|
|
Thread Tools | Display Modes |
|
|||||||
| RX-7 2nd Gen Specific (1986-92) RX-7 1986-92 Discussion including performance modifications and technical support sections. |
|
|
Thread Tools | Display Modes |
09-09-2009, 08:49 PM
|
#3 |
|
Rotary Fan in Training
Join Date: Feb 2008
Location: SW OKC
Posts: 75
Rep Power: 18  |
I would run a rotary a bit richer than a piston motor due to the heat it creates. I like to taper from 12.5 to 11.5 A/R from 0 PSI to about 8, obviously around 1,2,3 its pretty close to 13 or so. From 8 to 15 PSI like to taper it closer to 11 A/r. From there I continue to get richer. Hope that helps. Good luck.
__________________
If you wanna become ASE certified buy the RX7. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode