Lower LIM gasket/spacers

speedjunkie · 12-23-2010, 02:56 AM

It's a 13B-REW with GZ LIM and CJ Motorsports fuel rails. Trust me, they're rubbing, my roommate has the same problem with his setup, and a spacer fixes it.

We got the spacers back from the waterjet guy today and they are GORGEOUS. And they fit too. I'll take some pics and post up tomorrow. After testing them for a while I'll post results and if everything is good I'll offer them to whoever wants some, and I'll figure out a price by then too. I don't think it'll be too expensive though.

Oh, and I'm not spacing the UIM, I'm spacing the LIM from the block.

GoopyPerformance · 12-23-2010, 09:43 AM

We have lower intake manifold spacers for all years in stock.
From 3/8" to 3/4..1/2" being the most common.

For all your fabrication needs.

God Bless

Goopy Performance
info@goopypermance.com

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

12-23-2010, 02:56 AM	#1
speedjunkie RCC Loves Me Not You Join Date: Mar 2008 Location: Colorado Springs, CO Posts: 2,089 Rep Power: 20	It's a 13B-REW with GZ LIM and CJ Motorsports fuel rails. Trust me, they're rubbing, my roommate has the same problem with his setup, and a spacer fixes it. We got the spacers back from the waterjet guy today and they are GORGEOUS. And they fit too. I'll take some pics and post up tomorrow. After testing them for a while I'll post results and if everything is good I'll offer them to whoever wants some, and I'll figure out a price by then too. I don't think it'll be too expensive though. Oh, and I'm not spacing the UIM, I'm spacing the LIM from the block.