advice

fcrotory · 01-11-2011, 01:10 AM

Theres no way my primary plugs would reach to secondary injectors. And the car was super flooded when I finally got it started. It has premix in the tank cause the original s4 setup was premix only. No mop. so I pulled egi fuse and cranked engine. It spuddered till it cleared out, then was idling so sweet. But couldn't rev fast. And with the s4 motor setup, we swapped some plugs to run s5 ecu and harness. It ran the exact way it does now with all s5 components. So I know its not the initial swap of everything. Something is not working or not recieving the right signal. When we had the afm off and shake it, u can hear something loose in there but its stuck inside somewhere. I need to Jus start checking all sensors for the right ohm reading??? Anything else I can do? Appreciate the help guys.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

01-11-2011, 01:10 AM	#17
fcrotory The Newbie Join Date: Jan 2011 Posts: 7 Rep Power: 0	Theres no way my primary plugs would reach to secondary injectors. And the car was super flooded when I finally got it started. It has premix in the tank cause the original s4 setup was premix only. No mop. so I pulled egi fuse and cranked engine. It spuddered till it cleared out, then was idling so sweet. But couldn't rev fast. And with the s4 motor setup, we swapped some plugs to run s5 ecu and harness. It ran the exact way it does now with all s5 components. So I know its not the initial swap of everything. Something is not working or not recieving the right signal. When we had the afm off and shake it, u can hear something loose in there but its stuck inside somewhere. I need to Jus start checking all sensors for the right ohm reading??? Anything else I can do? Appreciate the help guys.