Falcore

Force13b · 02-10-2011, 03:32 PM

Since heat is the enemy double so in a rotary i heat insulated the underside of the UIM. As things go for time consumption Polishing is #1 this takes a close 2nd.

Clean the ever living snot out of the UIM get every last piece of grease i can possibly scrub off of it

Start application

Finish

The Fuel system took me a while. I spent to much time cleaning.

Switched to MSD coils for primarys and Escalade coils for secondarys

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

02-10-2011, 03:32 PM	#2
Force13b cxxxx\|::::::::::::> Join Date: Nov 2009 Posts: 315 Rep Power: 17	Since heat is the enemy double so in a rotary i heat insulated the underside of the UIM. As things go for time consumption Polishing is #1 this takes a close 2nd. Clean the ever living snot out of the UIM get every last piece of grease i can possibly scrub off of it Start application Finish The Fuel system took me a while. I spent to much time cleaning. Switched to MSD coils for primarys and Escalade coils for secondarys