93 BB base FD build-up

[Garfinkles Motor Works]

Do polished parts make you blind ,what shall I do . Dan can not have his engine torque brace link unless I get a ride .

[Chadwick]

Originally Posted by Garfinkles Motor Works

Do polished parts make you blind ,what shall I do . Dan can not have his engine torque brace link unless I get a ride .

hahaha, of course you can have a ride.


Updated the second post with some picture after I added the second element to the wing. I have decided that the second element needs to be about 1" lower and will do that first thing in the morning.

Seems we have chased down most of the gremlins and should be putting her on the dyno tomorrow right after we finish up the internal wiring. The dual EGT and XD-16 guage are working great; just have to install the Tripower gauge pod in the right place. I'm pretty impressed with the XD-16, very nice display and easy to read even sitting on the passenger floor board .

After a week of heat cycles on the motor it is now pulling 18"-19" of vacuum at idle which I have down to 900rpm now. Air fuel is low to mid 12's so I have some tuning to do. It also has a pretty bad lean tip in that I will have to work out.

Dan

[Chadwick]

Ran into several issues today installing the carputer and LCD. Took us almost 8 hours to finish off the wiring and get the interior all back together.

We had another RX7 come into for a fender roll and tune so I never got my car on the dyno. We will be putting some breakin miles are her tomorrow and get her on the dyno around mid week.

The list of things to get done is getting shorter:

1. Install Kazz LSD and 4.77 ring and pinion
2. Pull off front bumper and hood, prime and put back on.
3. Install undertray, front spoiler, feed side skirts, front combo lights and oil cooler ducts
4. Alignment and corner balance
5. Install surge tank cover
6. Tune
7. Mount Hoosier A6’s on wheels