Removed rear plate.

JunpoweR · 05-08-2008, 04:34 AM

Your side seals are stuck
you need to give everything a through cleaning and everything should be fine.
I would replace the side seals and springs in this situation.
Also get FD conner seal springs and thoughly clean and measure for specs.
Those areas where the side seal and conner seal meet often too out of spec to reuse.

Smoking at start up is probably worn oil controll rings it will seep past the side seals into the combustion chambers!

05-08-2008, 04:34 AM	#3
JunpoweR Rotary Fan in Training Join Date: May 2008 Posts: 66 Rep Power: 0	Your side seals are stuck you need to give everything a through cleaning and everything should be fine. I would replace the side seals and springs in this situation. Also get FD conner seal springs and thoughly clean and measure for specs. Those areas where the side seal and conner seal meet often too out of spec to reuse. Smoking at start up is probably worn oil controll rings it will seep past the side seals into the combustion chambers! __________________ --^v--JunpoweR--^v-- "90 GTUs Crystal White GT35 WB TA Project "90 GTUs Brilliant Black Restoration 1984 GSL-SE Daily

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode