im back in an FC!! - Rotary Car Club

		Rotary Car Club > Tech Discussion > Show your rotary car build up.
im back in an FC!!

Show your rotary car build up. Show off your Rotary Car build!

Thread Tools

Display Modes

07-21-2013, 02:55 PM

#10

WE3RX7

RCC Addict

Join Date: Feb 2008

Location: VA

Posts: 1,812

Rep Power: 19

Quote:

Originally Posted by 88turboii

yes super simple, they are threaded on both sides, but have an allen wrench fitting on one end to make it easy to thread into the front iron, then you just torque the nut to spec

Sweet, didn't know if they were stock sized or if milling was needed. I will probably go this route on the next engine I put together....

Bookmarks

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Forum Rules

Forum Jump

All times are GMT -5. The time now is 10:04 PM.