Mazdabaters peice of crap FC.

Mazdabater · 01-25-2015, 06:05 AM

Made some progress today. First time at a manifold, the 42r doesn't leave many options due to the sheer size of it. Will have to run an airline from my landlords shed tomorrow so I can bust out my die grinder and finger linisher. Took a bit to much meat off where the 2 pipes join before the t4 flange and ones 10mm bigger then the other. I was only using a 5" grinder however. Was unsure how I was going to go about it so I just had a crack

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

01-25-2015, 06:05 AM	#39
Mazdabater FC3S Join Date: Jun 2010 Location: Townsville, QLD, AUS Posts: 326 Rep Power: 16	Made some progress today. First time at a manifold, the 42r doesn't leave many options due to the sheer size of it. Will have to run an airline from my landlords shed tomorrow so I can bust out my die grinder and finger linisher. Took a bit to much meat off where the 2 pipes join before the t4 flange and ones 10mm bigger then the other. I was only using a 5" grinder however. Was unsure how I was going to go about it so I just had a crack