|
|||||||
| RX-7 3rd Gen Specific (1993-2002) RX-7 1993-2002 Discussion including performance modifications and Technical Support Sections. |
|
|
Thread Tools | Display Modes |
|
|||||||
| RX-7 3rd Gen Specific (1993-2002) RX-7 1993-2002 Discussion including performance modifications and Technical Support Sections. |
|
|
Thread Tools | Display Modes |
03-03-2008, 05:32 PM
|
#2 |
|
The Judge
Join Date: Feb 2008
Posts: 196
Rep Power: 18  |
There are two clockings. The CHRA should be clocked for best oil flow (top to bottom) if posible but it does not have to be pure verticle. If the fittings for oil or water have clearance problems, just rotate a little. But I would not have the oil lines off more than 45 degrees from vertical.
Clock the compressor housing for best fit of you pipes. Last edited by cewrx7r1; 03-04-2008 at 12:41 PM. |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode