Rotorhead87's Cosmo 13B-RE FC3S build-up

rotorhead87 · 02-02-2009, 12:19 PM

WooHoo!!! I finally got my stainless steel fuel and return lines completed. All I can say is that they are beautiful. I had the lines bent exactly to the factory lines. They're definitely noticably larger in diameter then factory lines. For my fuel lines I'm running 1/2'' inch, and as for my return lines I'm using 3/8'' inch.

All we have to do is plumb the lines in and then the fuel system is completed. The motor is not quite ready to fire up, but it's getting VERY close. Just need to finish up all the little things that seriously adds up quick.

02-02-2009, 12:19 PM	#22
rotorhead87 Rotors > Pistons Join Date: Sep 2008 Location: Port Saint Lucie, Florida Posts: 316 Rep Power: 18	WooHoo!!! I finally got my stainless steel fuel and return lines completed. All I can say is that they are beautiful. I had the lines bent exactly to the factory lines. They're definitely noticably larger in diameter then factory lines. For my fuel lines I'm running 1/2'' inch, and as for my return lines I'm using 3/8'' inch. All we have to do is plumb the lines in and then the fuel system is completed. The motor is not quite ready to fire up, but it's getting VERY close. Just need to finish up all the little things that seriously adds up quick. __________________ *UPDATED 06/15/2009* Check out My VMIC Turbo 13B-RE FC3S build

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode