Rotary Car Club - Underhood temps

Rotary Car Club (https://rotarycarclub.com/index.php)

- RX-7 2nd Gen Specific (1986-92) (https://rotarycarclub.com/forumdisplay.php?f=37)

- - Underhood temps (https://rotarycarclub.com/showthread.php?t=4688)

Quote:

Originally Posted by My5ABaby (Post 53080)

I was just looking off www.WaytekWire.com for the wire and terminals. I've seen sites with pre-made harnesses, but I doubt any would work well with the 7. Most are for old hot rods.

Do you have any idea how much I Love you right now (in a non-homo kind of way)? I've been looking for cannon plugs for ages and they sell them. Not only do they sell them, they sell them dirt cheap! Sure they're not the super high density, but this way I can finally do a full on custom harness! :D

so what gauge are you going with? 10GA? I don't think wytek has any (semihigh-density) cannon plugs for that ga. :( I may be looking again:(

is there any problem with running 14GA or 16GA? Too much current?

I was going to replicate the stock gauging on most things, and go up a bit on some (grounds/starter/etc.).