I just have to clean the other stuff off the parts you are looking at 50$ total plus shipping which was a guess at 25$ UPS ground I will firm up that quote for you but it will take a couple of days as we are scattered across the country right now

I added the dust covers (or caps, whatever they are called) that go over the bearings as well if that is ok. Does that change the price?

I will take it either way. Do you take paypal or something else? I will PM you my info.

If i am correct you need the tube/spindle 84-5 with all spindle hardware, dustcaps and backing plates correct?

So i will be removing the struts, springs, rotors, and calipers.

If that is good I am sure that I can do it for a total of 75$ shipping included paypal is rotarydave@aol.com, parts will be going out on Wed please include good shipping address

That is correct

I sent the payment with the address. PM me if there is anything else you need.

do you have a stock wing

Dave,
I need the following, all for an 83 GSL:
Set of power window switches
Heat/A/C control unit (manual one with the sliders and knob)
Passenger headlight motor with good splines and a good arm with nylon washers still
Passenger headlight door/cover/lid thing
Header panel (metal panel between the lights)
Front bumper cover
Any kind of front spoiler (I need a picture first, looking for function over form)

It would be shipped to WA 98626 so obviously the header panel and front bumper are highly dependent on price/shipping.

wing
 

I need more info on the wing you are looking for there are a few different versions of wings that are out there.

Parts for P71
 

I need the following, all for an 83 GSL:
Set of power window switches (got some but I need to rehab them and check to make sure they are good)
Heat/A/C control unit (manual one with the sliders and knob) (got plenty no problem)
Passenger headlight motor with good splines and a good arm with nylon washers still (Got the motor don't know about the arm do you need both or which one short or long)
Passenger headlight door/cover/lid thing (What color do you prefer)
Header panel (might be easier and cheaper for me to find you one in WA)
Front bumper cover (Same as above)
Any kind of front spoiler (don't have any aftermarket ft spoilers just stock)

Give me a couple of days to complete this list with conditions and a price
DAVE

Dave,
My passenger motor works but the splines are worn away so the motor spins but the short arm with the ball stays still. The long arm that goes from the ball on the motor to the headlight has no bushings so that's the arm I need. I prefer a Sunset Red Metallic lid but I'll take any color.
My header panel and front bumper are OK, they just need some bodywork so I figured I might try and find some better ones so I'll have less bodywork to do.

i dont know yet witch ones do you have?

I need a few things for an 85 GS.
I need a dust cover for the front wheel bearings.
The fuel door opener button/switch.
Passenger side mirror(power).
Exterior door handle.
All of the hardware for wiper arm studs. The nuts, spacers and covers. Especially the 2 big nuts that hold the studs through the cowl and body. That make any sense?
It all would be shipped to 40475.
Thanks

I need a small flange drive shaft for my early 83 GSL rear

i was wondering if you had the plastic pieces that cover the steering column
for an '85 fb

Dave, any updates on my parts it has been a month?

My parts came in and they are exactly what I needed, thanks. Also thank your wife for me for sending them out.