I still haven't had a chance installing this.. I'm hoping to start this weekend..

The mounting hole placement is different on the plates that are being made to send out .A better and stronger arangement .

have any of the brackets for the 3rd gen coils in stock? how would i place an order? how long should i expect it to take?

Same day shipping when check comes .

Sorry for the delay Garfinkle.

Here are a few pix of my installation. I will do a more in depth write-up when time allows.

http://img.photobucket.com/albums/v4...0630091857.jpg

http://img.photobucket.com/albums/v4...630091857a.jpg

looks good. Only difference than mine as seem in the first pictures is that I put mine on a slight angle. I did not want water to sit on top of the coils and give it a chance to mess with my connectors.
This way gravity allows it to roll off.

Are these still available? I have an FD with a T2 Coil.

Yes I have several for stock coils and for stock trailing and sec gen leading .Ready to ship.

Coil relocation bracket
 

I wanted to see if you still have any brackets for the third gen ('93 RX7 FD) stock T1 T2 coil packs. If so I'd love to get my hands on one. If you do still have one can you request a payment through paypal. My paypal ID is airboarder69@yahoo.com. Anyways let me know and when I get the payment request I'll approve it ASAP so you can ship it out. Thanks man.

-TC

I want one for stock FD coils! any available?

Sorry they are sold out. I have two for using the 2nd gen leading coil . I will make more of both when I have time . I will PM you but it may be a few days as I am behind schedule .

These do work with a RHD, except the spacing is quite limited due to a fluid hardline that runs right through that area, my Bracket is almost sitting on the subframe, and has a slight angle to it. (angled towards the rear of the car) its the only way it would fit.

But great build quality, Garfinkle makes some amazing products...


J.

Coil relocation plates are ready to ship,both types .4-23-2010

Still have the relocation plates for the FD LHD?

-AzEKnightz

Yes I have some ready to ship .

Sent you a PM about these.

Shipped it out 4-6-11 morning Thank You David

I got one FS with a 2nd gen coil. I'm not going to be using it, anyone want it?

Do you make new plug wires for these too? and how much? :)

I was making plug wires with 40 ohm MSD 8mm wire but I ran out .Sorry ,just recut your wires, either old or new.

Just found out my wife got the bracket in the mail this past Friday! Thanks again Garfinkle!

You are welcome stay safe

David

Received mine today thank you...

where can i get some of those drop in anchors. and what size and pitch are they....

Thanks again

Most auto parts stores .They are called Jack Nuts ,get 1/4 20 TPI .I can send you some if you need .

Can anyone tell me which wires on the stock harness go to which connectors on the FC Coil? I didn't receive any instructions. Thanks

Andy

The wires on the black connector that was on the stock leading coil .Get two eyelets and cut the black connector off and put the eyelets on the wires and bolt down with star washers if you can find them .Easy as that. You are the first to ask. If you need more help feel free to call.

Oh I apologize, I know about that. But the polarity doesn't matter and I can connect them to either terminal on the coil? I thought the two pins were different on the stock leading.

The wire color that is common to each coil goes to positive and the wire with green goes to neg