Rotary Car Club

Rotary Car Club (https://rotarycarclub.com/index.php)
-   Garfinkle's Motor Works (https://rotarycarclub.com/forumdisplay.php?f=80)
-   -   Replace the oil returm line with JIC fittings and braded line (https://rotarycarclub.com/showthread.php?t=11716)

Garfinkles Motor Works 06-10-2012 08:29 PM

I can make a set with JIC # 6 fittings for the twins.Do the new BNR s use the same gasket pattern as the stock twin .If no send me a gasket for a pattern .I have the programs for the T04 flange .
Why would yzf r1 be on my list ?

Monkman33 07-20-2012 01:19 PM

That message is in my sig, not referring to your settings at all. So no worries on that. :-)

Also, I am wondering if you are still making these?

I am also considering having the rear return be split so I can run a vent line off the top of it to prevent oil from filling up the intake/catch can. What are you thoughts on this? I have seen people use the rear return port for this purpose with single turbos and I was thinking it would be an effective way of getting the same benefits with twins. any thoughts? and do you think it is possible?

Smokey 07-23-2012 12:27 PM

Quote:

Originally Posted by Monkman33 (Post 209548)
I am also considering having the rear return be split so I can run a vent line off the top of it to prevent oil from filling up the intake/catch can. What are you thoughts on this? I have seen people use the rear return port for this purpose with single turbos and I was thinking it would be an effective way of getting the same benefits with twins. any thoughts? and do you think it is possible?

If you do this and it works please post it up. I've been searching for a solution and it seems the only one I've come across is to run a baffled oil fill neck and run the car about 3/4 of a quart low on oil which I don't like.

Garfinkles Motor Works 07-26-2012 08:15 AM

Monkman and I are working on a design, if there is enough room I can make the part .

Monkman33 07-27-2012 12:17 AM

I am looking at my twins to see what type of setup would be best. I will have some concepts and pics sent to you tomorrow hopefully.

Garfinkles Motor Works 08-17-2012 09:14 AM

I hope the parts I made for you work ,if not we will do the over untill they fit .


All times are GMT -5. The time now is 02:38 AM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Hosted by www.GotPlacement.com