Got em here is you arrow leds.

http://www.signal-construct.de/index...infolamps.html

Another

http://www.conrad.com/LED-indicator-..._17318_0233517

These guys are in the US and can get Signal-Construct stuff.

http://www.alliedelec.com/

That's the site I pulled the PDF from. I've emailed them, but no response yet.
Thanks. Now to see if they'll accept international orders... It looks like they don't ship to the USA.

He says USA and Canada but it says because of high insurance costs. So maybe he will since you will be ordering such few LEDs. If not get a hold of http://www.alliedelec.com/ they are in the US and seem to be able to get Signal-Construct products.

I may end up going with these to make my life easier:
http://www.kingbrightusa.com/categor...angular&Page=1

I'd prefer
http://www.ledtronics.com/Products/P...ls.aspx?WP=435

but with the minimum orders that makes it harder to deal with.

Or .... OR... just throwing this out here... go to radio shack and get some normal fricking LED's and be done with it..... just a suggestion :rofl:

I don't want regular LEDs for blinkers (too small, etc, etc, etc). For Brights indication and WBO2 indication will do. I'm actually going to hit up Radio Shack tomorrow and see what they have.

Well, I bought some regular old LED's, but I'm not going simple ;)

But this is a handy tool for people deciding to wire up their own LED's

http://led.linear1.org/1led.wiz

Remember: Anode (connect +) is the long lead from the LED, while the cathode (connect -) is the short.

I found what I'm going to replace the Innovate push-button and LED with:
http://www.frozencpu.com/images/prod...ain/ele-72.jpg

I'm also toying withe the idea that I will replace the IQ3 dash buttons with these similar type buttons:
http://www.frozencpu.com/images/prod...ain/ele-70.jpg

Thoughts?

(I'll be working on modeling the on the dash shortly)

What's the OD of them?

The OD mounting spec is 16mm, with the bezel it comes to just shy of 18mm

Kinda big to put on the dash, no?

They're a bit bigger than I would like; yes. But they seem to fit without issue on the dash. I'll post up a work in progress which shows the mounting holes:

Whats the space for the one gauge it looks like you've got on the outside?

Here's what the Dash looks like with those buttons. I don't know how to simulate leather wrapping on it, but you get a pretty good idea of what's going on anyways.

Are you talking about the hole on the left side? If so it's the Fuel level gauge.