looks good. Only difference than mine as seem in the first pictures is that I put mine on a slight angle. I did not want water to sit on top of the coils and give it a chance to mess with my connectors.
This way gravity allows it to roll off.

Are these still available? I have an FD with a T2 Coil.

Yes I have several for stock coils and for stock trailing and sec gen leading .Ready to ship.

Coil relocation bracket
 

I wanted to see if you still have any brackets for the third gen ('93 RX7 FD) stock T1 T2 coil packs. If so I'd love to get my hands on one. If you do still have one can you request a payment through paypal. My paypal ID is airboarder69@yahoo.com. Anyways let me know and when I get the payment request I'll approve it ASAP so you can ship it out. Thanks man.

-TC

I want one for stock FD coils! any available?

Sorry they are sold out. I have two for using the 2nd gen leading coil . I will make more of both when I have time . I will PM you but it may be a few days as I am behind schedule .

These do work with a RHD, except the spacing is quite limited due to a fluid hardline that runs right through that area, my Bracket is almost sitting on the subframe, and has a slight angle to it. (angled towards the rear of the car) its the only way it would fit.

But great build quality, Garfinkle makes some amazing products...


J.

Coil relocation plates are ready to ship,both types .4-23-2010

Still have the relocation plates for the FD LHD?

-AzEKnightz

Yes I have some ready to ship .

Sent you a PM about these.

Shipped it out 4-6-11 morning Thank You David

I got one FS with a 2nd gen coil. I'm not going to be using it, anyone want it?

Do you make new plug wires for these too? and how much? :)

I was making plug wires with 40 ohm MSD 8mm wire but I ran out .Sorry ,just recut your wires, either old or new.