Rotary Car Club

Rotary Car Club (https://rotarycarclub.com/index.php)
-   DGRR Archive (https://rotarycarclub.com/forumdisplay.php?f=204)
-   -   DGRR 2012 To Do List (https://rotarycarclub.com/showthread.php?t=15161)

Sephitrask 04-13-2012 08:16 AM

Well only one is leaking right now, but with 100k miles on them i'm replacing the pair.

djmtsu 04-13-2012 11:47 AM

Are they stock?

I have a complete set of 50K struts with springs, top hats, everything assembled taking up space in my garage ;)

Proxy One 04-13-2012 12:26 PM

My To Do list is getting smaller.

Clutch Change to 6 puck Sprung. Release and Pilot Bearing -DONE
Fix a few minor oil leaks - DONE
Change Tranny Fluid over to NEO - DONE
Bleed Clutch with ATE Super Blue - DONE

Still Need to do:
Fix Radio issue with grounding (need tunes on the Gap)
Fix Cigarette Lighter Socket not working
Change intake filter on turbo (its in the mail)
Fix leaking power steering line on reservior, needs new clamp I think.
Change oil

Sephitrask 04-13-2012 12:27 PM

Quote:

Originally Posted by djmtsu (Post 189636)
Are they stock?

I have a complete set of 50K struts with springs, top hats, everything assembled taking up space in my garage ;)

They have s techs on them (that may be another factor besides their age that did it, lol) Plus I need them on tomorrow, since I am working sunday-wednesday, and am not about to drive to Deals gap with a blown shock, seems like a very bad idea. Thanks though, I appreciate it!

N.RotaryTech 04-13-2012 03:07 PM

This weekend I will be doing: a radiator swap, fix exhaust leak, fabricate a heat-shield for the intake, tune, check brakes and everything else, wash the car cause it is dirty!


Procrastination.

willnordacgreen1211 04-13-2012 08:43 PM

almost ready! gotta swap out an axle, and hopefully get my sparco seat installed and im ready to go!

rgould 04-14-2012 06:19 PM

Our to do list
 
Our 82 GSL:tongue1:

1) Remove, disassemble, clean, powder coat, and rebuild brakes on all corners. Done
2) Flush brake system. Done
3) Replace rear hatch lift rods. Done
4) Change oil and filter. Done
5) 500 mile shake down. Done
6) Final clean up. To do

Our 93 R1:drool5:

1) Change oil and filter. Done
2) Flush and change coolant. Done
3) Change spark plugs. Done
4) Add shift light and tach. Done
5) Shake down. To do :driving::driving:
6) Final clean up. To do

N.RotaryTech 04-15-2012 11:45 AM

Radiator swap = Done.
Check brakes and everything else = Done.
Tune = Done.
Wash car = Done.

And that how it will roll.

willnordacgreen1211 04-15-2012 03:11 PM

powertrix coilovers-DONE
carbon fiber trunk and lip spoiler- DONE
new plugs/coils/wires- DONE
new starter-DONE
cobb ap installed and tuned- DONE
replace axle-DONE
air pump delete- DONE

all thats left is align it and wash it!

88turboii 04-15-2012 07:03 PM

i get everything done, and installed 1600's this weekend, but then had a bunch of fuel leaks pop up. hopefully get it fixed by thursday! that and need to change the oil and i should be ready

Sephitrask 04-15-2012 10:16 PM

I have the passenger side suspension done, I have to do the shock/endlink for the drivers side on Tuesday when the parts come in then an alignment on Wednesday.... Talk about last minute!!

Rotorypolo 04-16-2012 12:05 PM

To do list on 94 (friend's car)
-remove old engine- tranny, drop in new engine - tranny - done long time ago
-convert old single setup to simplified seq. setup - done
-put in new stock turbos - done
-blew stock twins on dyno ( bad turbo from ebay!) cough cough
-install new GT35R turbo / convert to single, etc etc - done
-install shitty ebay intercooler - done
-dyno tune on shitty chinese IC - done (found exhaust leak and major heat soak)
-install new coilover suspension - done
-install new fuel pump and fix floater - done
-install short shifter - done
-fix exhaust leak- done
-reroute waste gate open dump - done
-install new cat-back exhaust - done
-new 1.06 hot side - done
-new V-mount IC setup - done
-fix minor vacuum leaks - done
-new injector resistors & wiring - done
-a good tuning - done (FINALLY)
-install and wired up new water temp gauge - done
-fix injector leaks - done
-install new front rotors and pads - done
-change plugs - done
-fix broken door locks, handles, etc. - done
-retrofit projector HID headlight - done
relocate battery to rear - done

Still to do list
-install rear rotors and pads
-install alum. AST
-new paint job
-cut stock hood, install hood vents
-install Mazdaspeed GTC front
-install remote entry
-sound system/headunits
-NEVERENDING maintenance, and upgrade

Sephitrask 04-16-2012 07:47 PM

Quote:

Originally Posted by Rotorypolo (Post 189928)
To do list on 94 (friend's car)
-remove old engine- tranny, drop in new engine - tranny - done long time ago
-convert old single setup to simplified seq. setup - done
-put in new stock turbos - done
-blew stock twins on dyno ( bad turbo from ebay!) cough cough
-install new GT35R turbo / convert to single, etc etc - done
-install shitty ebay intercooler - done
-dyno tune on shitty chinese IC - done (found exhaust leak and major heat soak)
-install new coilover suspension - done
-install new fuel pump and fix floater - done
-install short shifter - done
-fix exhaust leak- done
-reroute waste gate open dump - done
-install new cat-back exhaust - done
-new 1.06 hot side - done
-new V-mount IC setup - done
-fix minor vacuum leaks - done
-new injector resistors & wiring - done
-a good tuning - done (FINALLY)
-install and wired up new water temp gauge - done
-fix injector leaks - done
-install new front rotors and pads - done
-change plugs - done
-fix broken door locks, handles, etc. - done
-retrofit projector HID headlight - done
relocate battery to rear - done

Still to do list
-install rear rotors and pads
-install alum. AST
-new paint job
-cut stock hood, install hood vents
-install Mazdaspeed GTC front
-install remote entry
-sound system/headunits
-NEVERENDING maintenance, and upgrade

interested in the "cut stock hood install hood vents" part. what vents are you using, and do you have any pictures of your idea?

Rotorypolo 04-16-2012 08:25 PM

It is the 9Kracing hood vents
see here
http://www.9kracing.com/new-batch-of...ng-hood-vents/
Here are some pictures i found on the internet of this hood on FD
http://www.rx7club.com/showthread.php?t=843724&page=21

estevan62274 04-17-2012 02:43 PM

Alignment..... DONE!
Plugs....... DONE!
Oil change......DONE!

She's ready and I'm so for this years DGRR!:patriot:


All times are GMT -5. The time now is 08:55 AM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Hosted by www.GotPlacement.com