Need help with LIM Flange!
 

Hey guys,

I need some help with a LIM flange. I need either a scan of a lower intake gasket (flange to motor) for a 6PI engine, and give me an accurate measurement of something on that scan. Could be a simple distance of a port.

Basically I'm looking for a single measurement and then I'll just scale the scan you did so I can get the rest. Any help with this would be greatly appreciated.

OR...

I need all the measurements on the flange (or gasket) itself.

Thanks

I've got a spare LIM if you want it.

You have a PM good sir