PARTING OUT: 93 Single Turbo Set up
 

UPDATE: PLEASE CONTACT ME BEFORE MAKING ANY PAYMENTS!!!!!

My paypal addy is: e_money@excite.com
Prices are with shipping unless other wise said.


Greddy Turbo Timer-$75 shipped

New Starter (manual)-$100 Shipped

LT8 Microtech with new wiring harness - $775 shipped

polished parts:

Subframe - $45 + SHIPPING

(polished everything)
Rare Blitz FMIC with piping - $950 + SHIPPING

Hi-Flow midpipe - $125 + SHIPPING

19" Stern (ADR) wheels and tires.
P275/30ZR19 Kumho Escta SPT rears 5k miles on them
P225/35ZR19 Conti Extreme DWS fronts 1k miles on them
$750 + SHIPPING

Hi, I would be really interested in several of your parts, i would like pictures of your UIM,LIM,TB,Alt,Apexi AVCR boost controller, complete fuel system,Banzai motor mounts and midpipes. would you combine shipping on multiple items and do you take Paypal? i'm in Atlanta,GA zip code 30043. How much power were you making on your setup? e-mail me at Gamma_rayburst@yahoo.com thanks.

UPDATE:
My paypal addy is: e_money@excite.com
Prices are with shipping unless other wise said.

Short block - $1800k app : 5k miles +SHIPPING

Greddy front strut mount bar - $90

Pettit AST w/cap - $80

banzai Poly motor mounts with engine mounts - $200 SOLD

5 Speed Transmission w/newer 5 gear sync - $400+SHIPPING
comes with short shifter.

XTR 6 puck clutch - $225
lightweight flywheel - $100
Or $300 together

Turbo Kit

Garrett T60-1 turbo (4k miles on it) - $375 SOLD
HKS 38mm wastegate (8k miles on it) - $275 PENDING
HKS manifold (cast iron/8k miles on it) - $300 PENDING
3" Custom downpipe w/ 3" V-band and O2 bung
- $175 SOLD


Custom Single turbo engine harness - $200 PENDING

Apexi AVR boost controler - $300 SOLD

HKS twin ignitor - $325 SOLD

E8 Haltech ECU with fling lead, WB 02 sensor and gauge - $1200
Or
$900 for ECU
$300 for sensor and gauge.

LT8 Microtech with new wiring harness - $800

LS1 coils,8mm plugs wires, 3 bar map - $125

Polished parts:
Alt - $75 SOLD
UIM - $125, has block off plates for single turbo SOLD
LIM - $100, has block off plates for single turbo
Acces. bracket - $50
Water Pump - $75
TB - $75 w/block off plates SOLD

CUSTOM FUEL SYSTEM:
1300 sec/850 pri (DENSO), SARD fuel regulator/AN lines and
fittings,and stock rails - $400 SOLD

Subframe - $75

Rare Blitz FMIC with piping - $1300
Greddy Type S BOV - $150
Greddy Elbow - $100 PENDING
(polished everything)
FOR EVERYTHING - $1400

Koyo rad (polished) w/Hoses - $300

Stock fans - $75

Rx7Store.com midpipe resonator - $225


HKS Ti CF can cat back - $300

Hi-Flow midpipe - $175

Driveshaft - $65

Solid Megan racing tie rod ends - $75

19" Stern (ADR) wheels and tires.
P275/30ZR19 Kumho Escta SPT rears 5k miles on them
P225/35ZR19 Conti Extreme DWS fronts 1k miles on them
$800 + SHIPPING

Everything is still in the vehicle and you can hear it run, up untill I start parting it out. If you want pics please let me know and I will try by best to get them to you with-in 24hrs.

UPDATE:
My paypal addy is: e_money@excite.com
Prices are with shipping unless other wise said.

Short block - $1800k app : 5k miles +SHIPPING

Greddy front strut mount bar - $90 PENDING

Pettit AST w/cap - $80 PENDING

banzai Poly motor mounts with engine mounts - $200 SOLD

5 Speed Transmission w/newer 5 gear sync - $400+SHIPPING
comes with short shifter.

XTR 6 puck clutch - $225
lightweight flywheel - $100
Or $300 together

Turbo Kit

Garrett T60-1 turbo (4k miles on it) - $375 SOLD
HKS 38mm wastegate (8k miles on it) - $275 PENDING
HKS manifold (cast iron/8k miles on it) - $300 PENDING
3" Custom downpipe w/ 3" V-band and O2 bung
- $175 SOLD


Apexi AVR boost controler - $300 SOLD

HKS twin ignitor - $325 SOLD

E8 Haltech ECU with fling lead, WB 02 sensor and gauge - $1200
Or
$900 for ECU
$300 for sensor and gauge.

LT8 Microtech with new wiring harness - $800

LS1 coils,8mm plugs wires, 3 bar map - $125

Polished parts:
Alt - $75 SOLD
UIM - $125, has block off plates for single turbo SOLD
LIM - $100, has block off plates for single turbo SOLD
Acces. bracket - $50
Water Pump - $75
TB - $75 w/block off plates SOLD

CUSTOM FUEL SYSTEM:
1300 sec/850 pri (DENSO), SARD fuel regulator/AN lines and
fittings,and stock rails - $400 SOLD

Subframe - $75

Rare Blitz FMIC with piping - $1300
Greddy Type S BOV - $150
Greddy Elbow - $100 SOLD
(polished everything)
FOR EVERYTHING - $1400

Koyo rad (polished) w/Hoses - $300

Stock fans - $75 PENDING

Rx7Store.com midpipe resonator - $225


HKS Ti CF can cat back - $300

Hi-Flow midpipe - $175

Driveshaft - $65

Solid Megan racing tie rod ends - $75

19" Stern (ADR) wheels and tires.
P275/30ZR19 Kumho Escta SPT rears 5k miles on them
P225/35ZR19 Conti Extreme DWS fronts 1k miles on them
$800 + SHIPPING

Everything is still in the vehicle and you can hear it run, up untill I start parting it out. If you want pics please let me know and I will try by best to get them to you with-in 24hrs.

Even take pics of the manifold? Also interested in the MAP sensor

UPDATE:
My paypal addy is: e_money@excite.com
Prices are with shipping unless other wise said.

Short block - $1700k app : 5k miles +SHIPPING

Greddy front strut mount bar - $80

5 Speed Transmission w/newer 5 gear sync - $350+SHIPPING
comes with short shifter.

XTR 6 puck clutch - $200
lightweight flywheel - $100
Or $275 together

E8 Haltech ECU with fling lead, WB 02 sensor and gauge - $1100
Or
$800 for ECU
$300 for sensor and gauge.
$200 for single turbo harness/haltech flying lead

LT8 Microtech with new wiring harness - $800

LS1 coils,8mm plugs wires, 3 bar map - $125

Polished parts:
Acces. bracket - $50
Water Pump - $75

Subframe - $75

(polished everything)
Rare Blitz FMIC with piping - $1300 + SHIPPING
Greddy Type S BOV - $150

Koyo rad (polished) w/Hoses - $300 + SHIPPING

Rx7Store.com midpipe resonator - $225 + SHIPPING

HKS Ti CF can cat back - $300 + SHIPPING

Hi-Flow midpipe - $175 + SHIPPING

Driveshaft - $65

Solid Megan racing tie rod ends - $75

19" Stern (ADR) wheels and tires.
P275/30ZR19 Kumho Escta SPT rears 5k miles on them
P225/35ZR19 Conti Extreme DWS fronts 1k miles on them
$800 + SHIPPING

Everything is still in the vehicle and you can hear it run, up untill I start parting it out. If you want pics please let me know and I will try by best to get them to you with-in 24hrs.

i suppose the HKS Exhaust manifold is sold?

Hi!rx7 man u still have the koyo rad n the HKS exhaust for sale if so wat cond? And miles anything wrong w it?ne special deal for both?n the shipping quote to 44310.thanks a lot

I may get the short block too,if u could tell me who build it ?or have ne warranty.thanks again

Interested in the short block as well but need specs... porting? seals? and who built it etc...

Ok sorry for the delay in responses. The manifold is sold sorry... I still have the rad for sale. I will post pics tomorrow.

The engine was rebuilt by Banzai Racing a little over a year ago. It was street ported, has 88 TII lower compression rotors and matching wieghts. It is 2mm seals. Sorry there is no warranty as Banzai only gives a year warranty with their rebuilds. But there is only around 5k miles on it, as I never got the tune done and so it was only boosted during a base tune and a short retune session by Chris at Banzai. So it is ready to go and all broke in. It compression tested in the high 90's on each rotor face.

UPDATE:

PRICE DROPS!!!

My paypal addy is: e_money@excite.com
Prices are with shipping unless other wise said.

Short block - $1700k app : 5k miles +SHIPPING

The engine was rebuilt by Banzai Racing a little over a year ago. It was street ported, has 88 TII lower compression rotors and matching wieghts. It is 2mm seals. Sorry there is no warranty as Banzai only gives a year warranty with their rebuilds. But there is only around 5k miles on it, as I never got the tune done and so it was only boosted during a base tune and a short retune session by Chris at Banzai. So it is ready to go and all broke in. It compression tested in the high 90's on each rotor face.



Greddy front strut mount bar - $80 Pending

5 Speed Transmission w/newer 5 gear sync - $375+SHIPPING Pending
comes with short shifter.

XTR 6 puck clutch - $200
lightweight flywheel - $100
Or $275 together

E8 Haltech ECU with fling lead, WB 02 sensor and gauge - $1100
Or
$800 for ECU
$200 for sensor and gauge.
$200 for Flying lead (wire harness)

LT8 Microtech with new wiring harness - $775

LS1 coils,8mm plugs wires, 3 bar map - $125

Polished parts:
Acces. bracket - $50
Water Pump - $75

Subframe - $75 + SHIPPING

(polished everything)
Rare Blitz FMIC with piping - $1200 + SHIPPING
Greddy Type S BOV - $125

Koyo rad (polished) w/Hoses - $300 + SHIPPING

Rx7Store.com midpipe resonator - $225 + SHIPPING

HKS Ti CF can cat back - $300 + SHIPPING

Hi-Flow midpipe - $175 + SHIPPING

Driveshaft - $65

Solid Megan racing tie rod ends - $75

19" Stern (ADR) wheels and tires.
P275/30ZR19 Kumho Escta SPT rears 5k miles on them
P225/35ZR19 Conti Extreme DWS fronts 1k miles on them
$800 + SHIPPING

UPDATE: PLEASE CONTACT ME BEFORE MAKING ANY PAYMENTS!!!!!

PRICE DROPS!!!

My paypal addy is: e_money@excite.com
Prices are with shipping unless other wise said.

Short block - $1600k app : 5k miles +SHIPPING

The engine was rebuilt by Banzai Racing a little over a year ago. It was street ported, has 88 TII lower compression rotors and matching wieghts. It is 2mm seals. Sorry there is no warranty as Banzai only gives a year warranty with their rebuilds. But there is only around 5k miles on it, as I never got the tune done and so it was only boosted during a base tune and a short retune session by Chris at Banzai. So it is ready to go and all broke in. It compression tested in the high 90's on each rotor face.



XTR 6 puck clutch - $200
lightweight flywheel - $100
Or $275 together

E8 Haltech ECU with fling lead, WB 02 sensor and gauge - $1000
Or
$700 for ECU
$200 for sensor and gauge.
$200 for Flying lead (wire harness)

LT8 Microtech with new wiring harness - $775

LS1 coils,8mm plugs wires, 3 bar map - $100

Polished parts:
Acces. bracket - $50
Water Pump - $75

Subframe - $75 + SHIPPING

(polished everything)
Rare Blitz FMIC with piping - $1100 + SHIPPING
Greddy Type S BOV - $125

Koyo rad (polished) w/Hoses - $275 + SHIPPING

Rx7Store.com midpipe resonator - $200 + SHIPPING

HKS Ti CF can cat back - $275 + SHIPPING

Hi-Flow midpipe - $150 + SHIPPING

Driveshaft - $65

Solid Megan racing tie rod ends - $75

19" Stern (ADR) wheels and tires.
P275/30ZR19 Kumho Escta SPT rears 5k miles on them
P225/35ZR19 Conti Extreme DWS fronts 1k miles on them
$800 + SHIPPING

i am sorry whats your location ?