do these look ok?
 

tell me what you think of this bridgeporting work

They look OK to me but i'm not a motor builder.

I think they look fine, but it is just a picture. Why are you asking, who did the porting?

I see a few things wrong with them, but you're not taking pics of the important parts

^ very true. what is the timing degrees of the opening and closing events?

Have you used an old rotor to make sure the leading side seal is still supported and that the trailing side seal doesn't scissor into the closing of the port causing it to chip?.
Otherwise they don't look too bad. good job man!!

Zack.