Part Out: 1985 S
 

I found enough rust in the rear end mount parts to to warrent a part out. All parts are in St. Louis, Mo.


Stock Nikki manifold $5

Front cross member $25

Custom aftermarket exhaust with unknown header, RB silencer and ebay fart can $150

rear hatch glass with defrost(was working) $20

Pro comp external fuel pump and regulator $50

12a bridge port with holley 650, RB intake manifold, 1 piece apex seals, solid corner seals, upgraded and corner springs. $300 might be willing to part.(This was my first ever rotary rebuild so it is sold AS IS)

Stock Gas tank(unknown condition $25 (I am willing to drop it and check if someone is seriously interested)

stock fuel pump $5

Junk original 12a housing X2 $20 each

12a front cover $10

alternator tested ok from autozone $10

Stock gauge cluster with a crack in plastic cover $10

working head light motors X2 $15 each

Stock rear end from drum to drum $100

stock driveshaft $5

Ford 302 engine mounts and AOD drive shaft(no transmission mount) $150

Tranny no grinds or issues when pulled $75

Oil pan $5

Used tension bolts $5

Stock exhaust with all cats $150

Tested working started $25

Dirty 12a rotors wit eccentric shaft $50 unsure of condition

Most pics can be found in the link below. If you need any up close shots just ask. Any part listed please post or pm and I will give you a price. Prices are without shipping. I will not ship larger items unless your willing to pay a premium for me to go to a shipping place and have them do all the work.

http://s179.photobucket.com/albums/w...%20Part%20Out/

One final note I will be on vacation from 10/24 - 10-28 and will be unable to answer questions during that window until I am back.

How much for the unknown header/silencer shipped to a business address 37167?

Also, are doing any interior parting out?

If so, I need storage bin lids, turn signal/headlight combo switch. Also, are all the locks for the doors/hatch good?

And, it looks like your stereo surround is broken? How much for the top section where the climate control section is (looks like that is all that is left anyway).

Thanks!!

The exhaust is one of the larger items I would prefer not to ship.

I will grab some pics of the bin lids, combo switch and all the locks/keys. Once I inspect them to make sure they are all good I will shoot you a price too.

You are correct the surround was broken by a thief a few months back. As with the above I will get the pics and condition of the climate control section.

If there is any of the other interior bits you need I have almost all of it, it has just been removed from the car.

Do you have a good Nikki?

I dont think its good. It was in a box when I picked up the car a while back. The screws on top were loose and the gasket under were ripped. It also looks like someone took the linkages off to try and make it a mechanical secondaries but could not get the throttle cam back on correctly lol. I believe I have almost all the parts removed from it. If you are interested in the base carb + all the parts I have its yours for $15 + shipping. I will take pics when I get home from the office.

That's kinds the same predicament I'm in. I've got 2 missing pieces and the one on the car needs rebuilding and I don't know anything about rebuilding one..
Thanks

Send me your Nikki, I can rebuild it!

Waffles: I will look into some options about the exhaust. I have shipped things like it before, it is easy, just cover it in cardboard and voila! The other stuff, please let me know. I really don't need much else from the interior since mine is burgundy (unfortunately). I am looking for the rear carpet though, and at least one good hatch strut, with hardware!!

So the combo switch didnt check out with the multimeter, so if you still want it, I will just throw it in for free if you buy anything else.

Here are the pics of the bins(did you want the whole bin or just the lids?):
http://i179.photobucket.com/albums/w...t/DSCF0818.jpg
http://i179.photobucket.com/albums/w...t/DSCF0819.jpg
http://i179.photobucket.com/albums/w...t/DSCF0820.jpg
http://i179.photobucket.com/albums/w...t/DSCF0821.jpg

Here is the exhaust. There is one hole in it but I can repair it before shipping if needed. I am talking to some friends for pointers on shipping exhaust.
http://i179.photobucket.com/albums/w...t/DSCF0826.jpg
http://i179.photobucket.com/albums/w...t/DSCF0827.jpg
http://i179.photobucket.com/albums/w...t/DSCF0828.jpg
http://i179.photobucket.com/albums/w...t/DSCF0829.jpg
http://i179.photobucket.com/albums/w...t/DSCF0830.jpg

All the locks were good and work with 1 OE key. The passanger side is missing its clip from the idiot that broke in but the lock still works fine. Did you need the ignition too?

http://i179.photobucket.com/albums/w...t/DSCF0825.jpg

For the stalk/bins/locks/ac piece in pic I am looking for $25 + shipping

I will try to get back to you asap about the exhaust.


If anyone is interested here is the pic of the carb + the extra parts.

http://i179.photobucket.com/albums/w...t/DSCF0822.jpg
http://i179.photobucket.com/albums/w...t/DSCF0823.jpg
http://i179.photobucket.com/albums/w...t/DSCF0824.jpg

Completely stripped shell with clear title is $300 or $500 as a roller if I haven't sold the suspension yet.

Detailed pics available on request.

I think the bins and lids are one piece...right? So I would need the whole bin.

Do you want to wait until you figure out shipping, or do you want me to pay for the other stuff first. Also, you know I want the broken plastic piece with the 3 holes for the clock/fan/temp right? Not the actual a/c controls.

Thanks again, and don't forget about the exhaust!

I did not realize you wanted the 3 hole part. Sorry. I will get a shipping quote for you this weekend.

NOTE: I leave for my honeymoon tomorrow. I will be back Friday. So, if you want anything and I don't respond, its nothing personal.

Ok, folks, now is a good time to low ball me. I need this all gone by 11/19. If you buy something(s) over $50 with a local pickup I will guarantee you will leave with extra free stuff.

List of sold parts:

Aftermarket Exhaust
Engine
Wheels
Lug bolts
Plate between the tail lights
Driver side fender
driveshaft
aftermarket fuel pump
Front spindle shocks and springs
Starter
rear hatch glass
junk motor in pieces

I would be interested in lower front valance, dash dimmer switch and power mirror switch, along with center console door and glove box door. I can come pick this up as well in mid december.