Rotary Car Club

Rotary Car Club (https://rotarycarclub.com/index.php)
-   Rotary Tech - General Rotary Engine related tech section.. (https://rotarycarclub.com/forumdisplay.php?f=131)
-   -   Seal organization (https://rotarycarclub.com/showthread.php?t=15444)

WE3RX7 02-20-2012 02:32 PM

Seal organization
 
With a nice four day weekend I got to have this weekend, I was able to spend some quality time with my daughter AND get a few things taken care of in the garage.

Something that I've been wanting to do for a while now is come up with a way to organize the seals during a rebuild. The Mazda factory seal boxes are nice, but at $100 on a box, it seems a bit overkill.

I use a nice metal workbench that I got at an auction for $25 for engine builds.... it has a nice pull out drawer that for a while was used as storage for misc parts and junk but I'm getting ORGANIZED finally.

I took the idea from the Mazda factory seal box and made this:

http://www.findtuners.com/FCProject/sealdrawer.jpg

I'm working on organizing rotors, bearings, etc as well to keep engine parts separated based on generation/type as well. The drawer has enough room to hold about 9 rotors, all bearings, all seals and dowels, etc.

Just thought I'd share the idea and I'm curious what others have done to organize seals during a build...

TitaniumTT 02-20-2012 03:05 PM

Pizza box and a sharpie works for me in a pinch ;)

I RARELY re-use seals, so it's a non event for me. i just lable them after they've beed fit and then I stack the short block, so I'm not storing them for very long. But if I were, that would be a good way to do it.

WE3RX7 02-20-2012 04:44 PM

Well.. U know how long I take on things lol...

Also.. Thus way I can clearance everything and drop it where it goes and come back the next day or so to stack..

N.RotaryTech 02-20-2012 05:18 PM

See my avatar.

Or ill keep the seals on the rotor with help of rubber bands.

rxspeed7 02-20-2012 07:03 PM

I made a really nice one out of a cigar box and some paint stirrer sticks, I'll take a pic of it and post it up super simple to make and only cost a few bucks.

WE3RX7 02-20-2012 08:03 PM

I used cigar boxes too, but no dividers, lol... didn't prove very useful for me :)

I like the diagram of the rotor.. I know another builder who uses drawings on cardboard ;)

2gslse 02-20-2012 08:37 PM

Quote:

Originally Posted by WE3RX7 (Post 182905)
I know another builder who uses drawings on cardboard ;)

I also used tape to hold them in place since my shop is so piled up that I can't see the floor unless I move the FD outside.

WE3RX7 02-20-2012 09:54 PM

Shouldn't you be driving the 9 hours back here instead of surfing the web? Hope all went well today...

2gslse 02-20-2012 10:26 PM

Quote:

Originally Posted by WE3RX7 (Post 182929)
Shouldn't you be driving the 9 hours back here instead of surfing the web? Hope all went well today...

any luck I won't have a car to drive. Time to buy new shoes.


All times are GMT -5. The time now is 08:46 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Hosted by www.GotPlacement.com