New Zealand mamber
 

Just going to post pics of some of my rotarys here, to get this section going:)

please check out my web site (its out of date and needs a clean up, but theres a few good pics)
The below pics are from the (or near) start of a 20b project I did a few years ago.

http://rotan20b.tripod.com/index.html

more 20b pic
 

more 20b pics, the smaller intercooler is a std 20b intercooler modded, the other one is a 600mm by 400mm? bar and plate. plus a pic of the inside.

some pic of my 8
 

Pics of the bolt ons and mods I've done to my rx8:)

some more 8 pics
 

some more 8 pics

13brew Cosmo Motor
 

another project I did, was a 13brew project, these motors have the same ports/plate as the 20b, out of the 13b's this would be my pick.
Note the clutch set up.

pics from a track day
 

pics from a track day, batterys ran flat, so only got 5 pics in:(

pics of rotarys I've had
 

pics of rotarys I've had.
2000 Series 8 Rx7 Batman type R, bought at 12,500 miles

series 1 and 2
 

Series 1 and 2 rx7's, the red series 2, I bought as a bare shell, and built up, couldn't get series two bumpers so used series one bumpers.

series 4/5
 

The Series 4/5's

WOW! Nice collection!

Quick question, is there a big rotary forum in New Zealand?? I would like the guys in New Zealand to know about RCCDigizine.com

Also, I would like to do a story about your collection if you don't mind...

rotary forum in nz
 

Not a collection anymore, all bar the rx8 have been sold, I should have kept at less the series 8 and series 2, but --- just needed the $$$$$

There are a few forums for rotary in New Zealand, but these are small in numbers compaired to this forum or rx7/rx8.com forums.
The rx8nz forum, I think has had the most of 18 people on it at one time, most days it'll be 2 or 3 members.
Here are some links to them--

http://rx8nz.web44.net/index.php

http://www.kiwirotary.com/phpbb3/index.php

http://mrec.rotary.net.nz/

Qustion for Herblenny
 

Herblenny, Would you mind if I post part of RCCDigizine.com, on a New Zealand Rotary (rx8nz) forum, with the link to it ??
The Decal RCC stickers how would I get some, and the cost??
Thank you-- Dave.

wow, you've been around the rotary block a few times!! Great taste man!

It has to be a smaller scene since you're all limited to the island. So far we've seen 3 NZ members and you all seem to be track-junkies!

Can wait to see more track events from there!

track
 

yip, hopping to get on the track tomorrow, as I Now have removed the 180k cut (JDM rx8) and have played with a few other things, along with the AME intake, Sould be a great.
I'll try and get the camera off the wife again so I can get some better pics this time:)

EDIT: opps.....somehow didn't see the 2nd page........


There are a couple of rotor websites around NZ, some i wouldn't really waste my time with..

Im a moderator on www.kiwirotary.com - Which doesn't have a huge amount of traffic goin through it ....
but there is also
http://mrec.rotary.net.nz/ - which is a good club based website
unsure of this 1:
http://www.getrotord.com/html/members_gallery.php

Trav.