TX-San Antonio Parting several SA/FBs
 

Ok guys, time has come to cull the herd again,

No really I have about 7 or 8 SA/FB bodys in various stages of disrepair. These are not complete cars we have had these cars for a little while none of them are in great shape. I will be crushing whatever is left on 1 May. I would do it sooner but I can't bring myself to destroy parts someone might need.

What parts are available, trannies, rear-ends, suspensions, some body parts, misc smaller interior pieces and trim. NO ENGINES, there are some engine, intake etc parts available.

All offers will be considered.

Dave, I might be interesed in a spare 5sp tranny. Do you have smooth cased one which were in good running order?

GSL-SE volume knob?

Trannys yes which one do you need I have a few of them. 79-80 or 81-5

Volume knob no I don't have any that are seperate from the whole radio

79-80

do you have any of the good parts like taillights? i need two good FB tails.

I will look and see on the FB Taillights.

I am sure that I have a couple of good used SA 5-speeds you would be looking at 150$ plus the shipping.

Any estimate on shipping tranny to 52722? No hurry.

Dave- I know its not on topic but Im getting closer to getting my repu road worthy again. PM me if you have a mirror like off your old red 77 and how much to 79749 (austin). thanks!

85rx7gslse - I think I saw all of the knobs for my old SE radio in my kid's room (??). I'll gather em up and send em all to you for free if I have the one you need.

Do you have any front spindles for an '84-'85 big bearing? I just need the spindle part and the dust covers, both sides. I don't need the struts, springs, rotors, calipers, or caliper brackets.

how much shipped to 80918?

IT will take a few days to get a shipping guess, Gary my friend and hobby partner that also does a little work out of the shop is currently picking up our new rx7 and delivering an Rx3 and won't be able to figure it out till he is back, unfortunately I am back in Kansas at training again. we will get it figured out.

I have had a good enough response to this that we are going to stay the execution of these cars to ensure you get what you need, admittedly it also doesn't hurt us as the $$ goes right back into preserving the others

You are wanting GSL-SE spindles correct? If that is the case I do have them but they aren't cheap you are still looking at 100$ before shipping (50 each side)

i think he might just want any 84-85 spindles.

yea if it is just the standard 84-5 spindle he wants I can do those much cheaper like 75$ total shipped

Yes it is the standard 84-5 spindles and dust covers that I need, not the SE.

Edit: I also was looking and I need the spindle nuts, retainers, washers, and dust covers.