Rotary Car Club - View Single Post

Flys · 12-03-2009, 02:39 AM

If you decide to make your own fuel rail, make sure you use the appropriate size ream bit. Also, radius the leading edge of the hole to allow the o-ring to squeeze in. Cratex bits work great for this, as well as the polishing Titanium mentioned.

12-03-2009, 02:39 AM	#7
Flys The Newbie Join Date: Dec 2008 Posts: 7 Rep Power: 0	If you decide to make your own fuel rail, make sure you use the appropriate size ream bit. Also, radius the leading edge of the hole to allow the o-ring to squeeze in. Cratex bits work great for this, as well as the polishing Titanium mentioned.