Rotary Car Club - View Single Post

WE3RX7 · 01-09-2010, 01:34 AM

I put this in the 2nd gen section, but these parts can apply to a custom FB project as well.

I'm cleaning the garage again and I am considering selling off my IDA parts I collected a few years ago when I planned to go EFI ITB on my FC project. I've long since changed directions on the project and don't really need these parts any more.

I have a simply maz 13b 4 port intake manifold that started to get polished, but I never finished. It was never installed, all gasket surfaces are clean and no damage at all to the runners.

I'd like to get $200 shipped (within 48 states) for this part. Retails for about $213 before shipping from AU.

I also have a custom top hat plenum that will mate up to any Weber IDA style throttle body. I'm looking for $320 shipped for the plenum.

This could very easily be used to create a boosted carb setup as well with IDA 48s or larger.

I dont mind holding onto these parts until my next project, but I thought if they could go to a good car now, all the better. Let me know if you have any questions. I'll get some pics up shortly.

01-09-2010, 01:34 AM	#1
WE3RX7 RCC Addict Join Date: Feb 2008 Location: VA Posts: 1,812 Rep Power: 19	FS/GI: IDA/ITB manifold and plenum I put this in the 2nd gen section, but these parts can apply to a custom FB project as well. I'm cleaning the garage again and I am considering selling off my IDA parts I collected a few years ago when I planned to go EFI ITB on my FC project. I've long since changed directions on the project and don't really need these parts any more. I have a simply maz 13b 4 port intake manifold that started to get polished, but I never finished. It was never installed, all gasket surfaces are clean and no damage at all to the runners. I'd like to get $200 shipped (within 48 states) for this part. Retails for about $213 before shipping from AU. I also have a custom top hat plenum that will mate up to any Weber IDA style throttle body. I'm looking for $320 shipped for the plenum. This could very easily be used to create a boosted carb setup as well with IDA 48s or larger. I dont mind holding onto these parts until my next project, but I thought if they could go to a good car now, all the better. Let me know if you have any questions. I'll get some pics up shortly.