Alright, time for an update and because of the timing, they'll be coming ALOT more frequently.
I've got a few leads on the hardware that I need for the traction control, and I went and picked up the TCMux from my MoTeC dealer. Tomorrow I'm ordering the DMC-D's that I'll need to go from the Mag signal that the factory sensors puts out to the Hall Effect signal that the MoTeC needs to see. Also got some 20ga shielded Tefzel wire on order and I finally broke down and bought the $320 crimper that they need, and I figure while I'm at it I upgraded my other crimpers as well because we're gonna offer some sick wiring solutions 
Also managed to get the rest of the body stripped and last night we finally got her up on the rotisserie.
Already proped her to the side fo I can start the cleaning.
When I did start cleaning, I found that I opened up a can of fricken worms! I started with a wire brush and this was somewhat solid and not all the way through yet. Found a few of them actually, not pleased at all.
This is why we do NOT JACK FROM THE FUCKING PINCH WELDS!!!! The one on the other side is worse, but it was too high for me to get a pic
Don't know what caused the paint to fail here, but at least it's an easy fix
__________________
-The Angry Stig-
DGRR 2009, 2011, 2012 & 2013 - Best FC
DEALS GAP!! WOOHOOOO!!!!!
2015 Audi S4 - Samantha - Zero Brap S4
2004 RX8 - Jocelyn - 196rwhp, 19mpg fuel to noise converter
2000 Jeep Cherokee Sport - Wifey mobile - Now with 2.5" OME lift and 30" BFG AT KO's! So it begins
1998 Jeep Cherokee - 5 spd, 4" lift, 33" BFG's - Rotary Tow Vehicle
1988 'Vert - In progress
1988 FC Coupe - Gretchen -The attention whore BEAST!
I'm a sick individual, what's wrong with you?
I'm pure Evil
I'm still insane, in the best possible way.
I think Brian's idea of romance is using lube.
Your rage caused the meteor strike in Russia. The Antichrist would be proud of his minion.
You win with your thread. Most everything
It's a truck with a steel gate on the back. Just a statement of fact
Motec M820, AIM dash, ported 13B-RE Cosmo, 6-spd trans, 4.3 Torsen, custom twin wg fully divided mani, Custom 4" split into 2x 3" exhaust, Custom HMIC, Custom custom custom custom I like to welder stuff....
No Bolt-ons allowed. Dyno'ed @ Speed1 Tuned by me - 405rwhp on WG.... WM50 cuming soon.
-Angry Motherf*cker Mode ENGAGED-
Last edited by TitaniumTT; 02-07-2010 at 09:55 PM.
|