Quote:
Originally Posted by infernosg
LOL, thanks!
I actually already have a set of hub rings and everything works fine sans the slight contact in the front. My concern with the off-the-shelf spacers is their cooperation with my current hub rings. They're only like 10mm in thickness so if the 10mm spacer had a center bore of greater than 76mm (Enkei bore size) then the hub ring would end up inside the spacer and not really do anything. I know eBay sells the spacers that are supposedly hubcentric quoting hub bore as either 59.5mm or 60.1mm. If the former were true I could just put my current rings over the spacer and all would be good. I may end up going that route as, just depends on what the shop comes back with.
|
The problem with that ill be I don't believe the step is 10 mm. So the 10mm spacer may completely cover the centering step.
Quote:
Originally Posted by infernosg
Either way, I think I'm actually just going to have them quote a hubcentric 10mm spacer with the stock bore, then I'll just use my current hub rings. If anyone else were interested I feel this would get the best response - I'll see what a bulk price would be next week (probably Wed.).
|
See above
Quote:
Originally Posted by infernosg
One last question, I read another post here that in order to install longer wheel studs in the rear the hub has to be removed - is this correct?
|
That is correct.
__________________
-The Angry Stig-
DGRR 2009, 2011, 2012 & 2013 - Best FC
DEALS GAP!! WOOHOOOO!!!!!
2015 Audi S4 - Samantha - Zero Brap S4
2004 RX8 - Jocelyn - 196rwhp, 19mpg fuel to noise converter
2000 Jeep Cherokee Sport - Wifey mobile - Now with 2.5" OME lift and 30" BFG AT KO's! So it begins
1998 Jeep Cherokee - 5 spd, 4" lift, 33" BFG's - Rotary Tow Vehicle
1988 'Vert - In progress
1988 FC Coupe - Gretchen -The attention whore BEAST!
I'm a sick individual, what's wrong with you?
I'm pure Evil
I'm still insane, in the best possible way.
I think Brian's idea of romance is using lube.
Your rage caused the meteor strike in Russia. The Antichrist would be proud of his minion.
You win with your thread. Most everything
It's a truck with a steel gate on the back. Just a statement of fact
Motec M820, AIM dash, ported 13B-RE Cosmo, 6-spd trans, 4.3 Torsen, custom twin wg fully divided mani, Custom 4" split into 2x 3" exhaust, Custom HMIC, Custom custom custom custom I like to welder stuff....
No Bolt-ons allowed. Dyno'ed @
Speed1 Tuned by me - 405rwhp on WG.... WM50 cuming soon.
-Angry Motherf*cker Mode ENGAGED-