View Single Post
Old 04-08-2010, 04:21 PM   #1
DRTHVDR
Rotary Fanatic
 
Join Date: Feb 2008
Posts: 126
Rep Power: 18
DRTHVDR is on a distinguished road
MI: 1993 FD Part Out

First off....I'm keeping all interior, exterior and anything attached to the body harness.
All prices are "Or Best Offer". Shipping is NOT included.
I accept paypal and casheir checks and cash. All shipping will be completed AFTER payment has been recieved and cleared.
I have more pictures and don't hesitate to ask for more or any questions that you may have. I will do my best to answer to the best of my knowlege.

All photo's found here:
http://smg.photobucket.com/albums/v2...%20For%20Sale/

Aaron
PM me
aj_ws6@yahoo.com
248-931-1939

I'm located in SE Michigan.

I have a lot of little bits that are just sitting around. Lower intake manifold, Pulleys, solenoids, hoses, water pump, stock ast, New oil pipe gaskets, etc.

2 stock shifters: $20 each

Lower Intake Manifold (LIM): $40



Throttle Body: $100



Starter for manual trans: $50


Coil Pack: $135


Primary Fuel Rails w/500cc: $100


Water Pump body assembly: $60




Thermostat: $20


ATP-OIL-022 Oil Inlet Restictor - 0.65 hole size 1/8" NPT (for journal bearing and larger GT BB)
$10



Napa 13 lbs. Radiator Cap: $10


Stock Used Clutch (high miles): $25



Stock Used Flywheel (high miles): $40


Konig offset Wheels with Nitto NT450 225/45-17 on the front and NT555 255/40-17 in the rear.
Tires have barely been used. Less than 5k.
$400




__________________
You don't need a better ride, your ride needs a better driver.
93 RX-7 R1 CYM: Swap in progress
Other: 00 Impreza RS (GC8) & Odyssey Touring (Mommy Missile)

Last edited by DRTHVDR; 02-01-2012 at 08:27 AM.
DRTHVDR is offline   Reply With Quote