Ive got one block I might be willing to let go.
Its in pieces, and not pretty.
Its an S5 n/a, coolant seal track failure.
Condition:
Front iron: (Inner track rust-through to coolant passage), some pitting on the face, I also practice ported on that iron, also with a practice bridge port.
Front housing: A little bit of flaking on inside edges, lots of pitting on the outside, oil injector hole stripped, mating surfaces pitted, exhaust sleeve removed, I ported it too.
Front Rotor: Pitting on most sides, side seals stuck in, one corner seal stuck in, bearing good.
Intermediate Iron: Some pitting on front face, rear face good, I did small chamfer/bevel porting on top edge of ports.
Rear housing: Lots of flaking on inside edges, not as badly pitted on outside, oil injector hole might be stripped, exhaust sleeve removed, stock port.
Rear Rotor: Good.
Rear housing: Good, stock ports.
Eccentric shaft: Good.
Ive got all the hardware an front end parts, oil pan too.
No flywheel.
I want to make a cheap experimental crappy motor out of it.
Its still in process, but not going to be finished any time soon.
So make me an offer I cant refuse.
