[TitaniumTT]

Originally Posted by project86

hahaah Brian you do know i have been putting an air DA to cars for 2 years now right? I have a really nice Snap On DA and the compressor im buying will be plenty for it to work

Hey man, I gotta 60 gal Cambel Hausfeld 13.5 hp air comp and after DA'ing for a while, it gets warm. Just a suggestion, though I bet the Snap-on DA you've got uses alot less CFM than the one I have.

Originally Posted by project86

But i just had a thought last night that i was chattin with haukbeeb about. My dad actually made me think about it.... im gonna rebuild my old engine and put it back in my car with a carb until its time for the super sweet other engine just so i can enjoy my car a little.

Im gonna buy some porting templates from pineappleracing.com and then i may buy a few porting tools from racing beat (unless someone can lend me some. I got the rotors cleaned up quite a bit yesterday and if all goes well im gonna have the irons hot tanked.

Then ill order a gasket and o ring kit from mazdatrix. i dont think it should cost me too much to do this and it will keep me happy till its time for the BIG project.

Gotcha, makes sense. I've got too many cars and not enough time to enjoy any of them. Today was the perfect example. I had today off, as well as tomorrow and the weekend. I went in early this morning, got there @ 8 to do a bunch of side job/captaining stuff............. I just got home.... 13 hours later. Now I'll be busting ass all night
swapping a front knuckle - powdercoating it first
building a heat shield for the fuel cell
installing an amp
swapping rear ends
and washing, compounding, glazing and waxing the car. If I get on the rd by dawn I'll be happy. Otherwise, no dyno tomorrow......... again