[sen2two]

I'm running a Jacobs FC1000 right now, which is basically the same thing as a MSD 6a. I want to run a MSD 2-step so I can have a controlled launch every time. I have searched all over on how to put in a 2-step, and just about every thread or piece of information says something different. Very contradictory and confusing when trying to learn...

So to make it easier on myself, I'm think of just swapping the FC1000 for a MSD 6al. Not the new 6al-2, but the older 6al. These come with a built in slot for a rev-limiter "pill". But i think instead of running a pill there, I can just plug an MSD 2-step in and be good to go.

But the main problem I think is that I will have the 6al wired to my leading coil pack only. So will the 2-step work, or give me the same effect, if the trailing coils arnt touched at all by this?