Rotary Car Club - View Single Post - Plain Jane OEM nothing to see here rebuild

RotorDad · 10-10-2010, 11:32 PM

Pulled from Mazdatrix who actually recommend the Renesis stationary gears. They are already hardend.
"If using the RX8 rear gear in an earlier 13b engine, you must add sealant where the rear gear o-ring WOULD be. There is no groove to hold the o-ring because the Renesis engine mounts the o-ring in the side housing rather than on the gear. We recommend using Hylomar, but a THIN layer of silicone sealant will also suffice."
The 3 window bearing IMO opinion is just as good as the REW multi window.

10-10-2010, 11:32 PM	#13
RotorDad Big Ugly Join Date: Apr 2009 Location: Fredericksburg, Va Posts: 591 Rep Power: 17	Pulled from Mazdatrix who actually recommend the Renesis stationary gears. They are already hardend. "If using the RX8 rear gear in an earlier 13b engine, you must add sealant where the rear gear o-ring WOULD be. There is no groove to hold the o-ring because the Renesis engine mounts the o-ring in the side housing rather than on the gear. We recommend using Hylomar, but a THIN layer of silicone sealant will also suffice." The 3 window bearing IMO opinion is just as good as the REW multi window. __________________ *Boosted Big Body On 335's* PS3 ID: Rotordad 1986 Mazda RX7 GXL - Street ported 13BT, Haltech, 62mm, ect. 2006 MazdaSpeed 6 - Eagle, Wiseco, Cobb, ect.