Quote:
Originally Posted by hIGGI
After years and years of doing it wrong way, last time i pulled out fan motor assembly (3 nuts and 2 or 3 easy accessible plugs) and wont do it otherwise anymore.....
Its much more convenient, no stress, no pain. I did it for haltech install, but dont see a reason to not do it for regular stock harness push-thru.
Old saying 'being lazy hurts' is usually very true  |
This is EXACTLEY what I was going to say. Some times is quicker to do more work to save some pain, removing the blower motor should take all of 3.5 minutes with a 10mm socket and some extensions. Then you have ALLLLL the access you'll ever need.
__________________
-The Angry Stig-
DGRR 2009, 2011, 2012 & 2013 - Best FC
DEALS GAP!! WOOHOOOO!!!!!
2015 Audi S4 - Samantha - Zero Brap S4
2004 RX8 - Jocelyn - 196rwhp, 19mpg fuel to noise converter
2000 Jeep Cherokee Sport - Wifey mobile - Now with 2.5" OME lift and 30" BFG AT KO's! So it begins
1998 Jeep Cherokee - 5 spd, 4" lift, 33" BFG's - Rotary Tow Vehicle
1988 'Vert - In progress
1988 FC Coupe - Gretchen -The attention whore BEAST!
I'm a sick individual, what's wrong with you?
I'm pure Evil
I'm still insane, in the best possible way.
I think Brian's idea of romance is using lube.
Your rage caused the meteor strike in Russia. The Antichrist would be proud of his minion.
You win with your thread. Most everything
It's a truck with a steel gate on the back. Just a statement of fact
Motec M820, AIM dash, ported 13B-RE Cosmo, 6-spd trans, 4.3 Torsen, custom twin wg fully divided mani, Custom 4" split into 2x 3" exhaust, Custom HMIC, Custom custom custom custom I like to welder stuff....
No Bolt-ons allowed. Dyno'ed @
Speed1 Tuned by me - 405rwhp on WG.... WM50 cuming soon.
-Angry Motherf*cker Mode ENGAGED-