Rotary Car Club - View Single Post

Pete_89T2 · 11-22-2010, 08:22 AM

A little off-topic, but since I started the thread and we got into the topic of engine hoists, what do you guys think of this one? (ref. link to Harbor Freight tools)

http://www.harborfreight.com/1-ton-c...ane-93840.html

Based on the reviews & specs, it sounds like this would suit my needs (occasional use on my RX-7s). There's a Harbor Freight store a few miles from my house that has it in stock, but it's not set up and on display for me to inspect. I like the fact that it's foldable and saves me some garage space. Cost is a steal - with the coupons I have, if I buy it on turkey day, it rings up at about $99.00

The question is would it have the reach & capacity to pull the engine/tranny out of an FC? Anyone out there own and use one of these?

11-22-2010, 08:22 AM	#1
Pete_89T2 Lifetime Rotorhead Join Date: Apr 2010 Location: Elkton, MD Posts: 874 Rep Power: 16	A little off-topic, but since I started the thread and we got into the topic of engine hoists, what do you guys think of this one? (ref. link to Harbor Freight tools) http://www.harborfreight.com/1-ton-c...ane-93840.html Based on the reviews & specs, it sounds like this would suit my needs (occasional use on my RX-7s). There's a Harbor Freight store a few miles from my house that has it in stock, but it's not set up and on display for me to inspect. I like the fact that it's foldable and saves me some garage space. Cost is a steal - with the coupons I have, if I buy it on turkey day, it rings up at about $99.00 The question is would it have the reach & capacity to pull the engine/tranny out of an FC? Anyone out there own and use one of these?