Rotary Car Club - View Single Post - New master cylinder, not pumping fluid while trying to bleed

need RX7 · 12-10-2010, 03:30 PM

I replaced my master cylinder today, and replaced all the bleeder screws with Russell Speed Bleeders. I topped off the master cylinder reservoir and tried pumping the brakes with the rear passenger bleeder open, nothing came out, no air or fluid. I tried opening all the bleeders and pumping away on the brake pedal, still nothing out of any of the bleeders after a few minutes. The level in the reservoir doesn't seem to be going down.

12-10-2010, 03:30 PM	#1
need RX7 Clean S4 Nutswinger Join Date: Mar 2008 Location: Sterling Heights, MI Posts: 485 Rep Power: 18	New master cylinder, not pumping fluid while trying to bleed I replaced my master cylinder today, and replaced all the bleeder screws with Russell Speed Bleeders. I topped off the master cylinder reservoir and tried pumping the brakes with the rear passenger bleeder open, nothing came out, no air or fluid. I tried opening all the bleeders and pumping away on the brake pedal, still nothing out of any of the bleeders after a few minutes. The level in the reservoir doesn't seem to be going down. __________________ -Ted -1986 Mazda RX7 Sport [DD/beater]: engine finally let go at 205k. parts car status. -1986 Mazda RX7 base [resto-mod project]: S5 n/a swap in progress.