|
I didn't port those ports.
Not yet anyway.
Imo, the lower ports look fine, but the aux ports are uneven, a little shloppy.
I looks like the corner seals might be about 1/3rd supported.
The bridge port motor.
I'm thinking I'm not just going to forget that motor.
I have a plan to sometime, put it back together, reusing the o-rings and other seals, and block off that one coolant passageway, then do an engine swap, maybe for just a few weeks, run it, take it for a mtn run, and get it dynoed, then swap the good motor back in.
Cause I still like that motor.
But for now, Im going with this street port motor.
|