Heres the A engine when I got it:
This is what all the oil control rings looked like.
The rotor bearings (like new, mostly silver with a touch of copper at the seams)
The damage the bolt did to the rear housing as it left the exhaust. I'm thinking
porting will take care of it. If not I'll use one of the other housings from engine B.
The right rotor shows a dent in the top edge of the combustion indent. None
of the apex seals got damaged and none of the apex seal slots looks
damaged. I think I can use the rotor? Opinions? Remember its a budget build.
__________________
1980 GS stockport, Fat Nikki, RB Dual Facetfuel pumps, Holley regulator, RB Street port exhaust, 2GDFIS, MR2 MK I electric fans, 2G strut bar, relayed fans, lights and fuel pump, LEDs
Project Fat Nikki Budget 12A rebuild Video setup < $30.00