|
Thread size request please!
I need the thread size of a bolt that goes bottom right corner rear iron that the tranny bolts up to. If that makes any sense.
This...
Right there.
Its an S4/S5 NA engine.
I think the same tread size goes to the bottom starter bolt hole too.
This really amazes me because Ive done a handful of rebuilds and this is the 1st time it seems that I never had a bolt in my possession that should go there.
__________________
'89 RX7 GTU, half-Bridge-port S4/S5 NA, E6K, Full RB exhaust, weekend warrior.
'83 RX7, The "this might take awhile" project.
'87 RX7 GXL, Rest In Pieces.
'98 Subaru Impreza Outback-sport, rx7 rescue vehicle, down for repair.
'94 Ford Ranger, daily.
|