Quote:
Originally Posted by NoDOHC
I'm with TTT, exactly what are you looking for data wise?
Do you want the housings sent to you?
Is it ok to disassemble the engine, take four pictures per housing (oil injector, exhaust port, compression area + Trailing plug, hole leading plug hole + expansion area) and post them here?
Do you want a glowing write-up, measurements, etc.?
The housing price seems realistic, the data deposit seems rather low to expect anyone to actually remove and disassemble their engine. Maybe compression readings would be sufficient?
I am willing to pull the engine, disassemble it and take pictures for posterity and the sake of research (no money involved), but I wouldn't disassemble it for $200.00, it would cost me almost that much in gaskets and seals.
|
That's the blunt way of making my point
__________________
-The Angry Stig-
DGRR 2009, 2011, 2012 & 2013 - Best FC
DEALS GAP!! WOOHOOOO!!!!!
2015 Audi S4 - Samantha - Zero Brap S4
2004 RX8 - Jocelyn - 196rwhp, 19mpg fuel to noise converter
2000 Jeep Cherokee Sport - Wifey mobile - Now with 2.5" OME lift and 30" BFG AT KO's! So it begins
1998 Jeep Cherokee - 5 spd, 4" lift, 33" BFG's - Rotary Tow Vehicle
1988 'Vert - In progress
1988 FC Coupe - Gretchen -The attention whore BEAST!
I'm a sick individual, what's wrong with you?
I'm pure Evil
I'm still insane, in the best possible way.
I think Brian's idea of romance is using lube.
Your rage caused the meteor strike in Russia. The Antichrist would be proud of his minion.
You win with your thread. Most everything
It's a truck with a steel gate on the back. Just a statement of fact
Motec M820, AIM dash, ported 13B-RE Cosmo, 6-spd trans, 4.3 Torsen, custom twin wg fully divided mani, Custom 4" split into 2x 3" exhaust, Custom HMIC, Custom custom custom custom I like to welder stuff....
No Bolt-ons allowed. Dyno'ed @
Speed1 Tuned by me - 405rwhp on WG.... WM50 cuming soon.
-Angry Motherf*cker Mode ENGAGED-