Rotary Car Club - View Single Post - Replace the oil returm line with JIC fittings and braded line

Garfinkles Motor Works · 03-27-2011, 10:19 PM

I will need to have a stock gasket to see if it is the same as FD.If it is not the same then I would need to write a new set of programes to cut the plate on the EDM .

03-27-2011, 10:19 PM	#15
Garfinkles Motor Works RCC Contributor Join Date: Mar 2008 Posts: 535 Rep Power: 18	I will need to have a stock gasket to see if it is the same as FD.If it is not the same then I would need to write a new set of programes to cut the plate on the EDM .