Quote:
Originally Posted by WE3RX7
Stand by on the call...
Did you end up needing longer wheel studs? Just curious as I'm trying to avoid spacers as well and wanted to make sure everything stays relatively the same as far as length is concerned.
|
I did, bought them just need to install them. I've also got a set of 5mm hubcentric spacers as well. I'm not so sure you'll need them though. I have a suspicion that my BBS's will actually fit. Still waiting to get the 'vert out to actually test them out. Either way though I'm installing the longer wheel studs.
The other option would be to run a different caliper. I believe the Superlite Narrows would fit my Works without interferance but I have yet to did up thier spec sheets and verify that.
What wheels/offsets are you running? I think the thing to do would be to get the hat and rotor and install them, bolt the wheel up and then make your choice in caliper....
__________________
-The Angry Stig-
DGRR 2009, 2011, 2012 & 2013 - Best FC
DEALS GAP!! WOOHOOOO!!!!!
2015 Audi S4 - Samantha - Zero Brap S4
2004 RX8 - Jocelyn - 196rwhp, 19mpg fuel to noise converter
2000 Jeep Cherokee Sport - Wifey mobile - Now with 2.5" OME lift and 30" BFG AT KO's! So it begins
1998 Jeep Cherokee - 5 spd, 4" lift, 33" BFG's - Rotary Tow Vehicle
1988 'Vert - In progress
1988 FC Coupe - Gretchen -The attention whore BEAST!
I'm a sick individual, what's wrong with you?
I'm pure Evil
I'm still insane, in the best possible way.
I think Brian's idea of romance is using lube.
Your rage caused the meteor strike in Russia. The Antichrist would be proud of his minion.
You win with your thread. Most everything
It's a truck with a steel gate on the back. Just a statement of fact
Motec M820, AIM dash, ported 13B-RE Cosmo, 6-spd trans, 4.3 Torsen, custom twin wg fully divided mani, Custom 4" split into 2x 3" exhaust, Custom HMIC, Custom custom custom custom I like to welder stuff....
No Bolt-ons allowed. Dyno'ed @ Speed1 Tuned by me - 405rwhp on WG.... WM50 cuming soon.
-Angry Motherf*cker Mode ENGAGED-
|