Quote:
Originally Posted by 2gslse
I doubt it is any good at all anymore it got a little H2O in it and it won't turn over at all now so boat anchor or core for a reman is all I would count it as.
|
Ah.... gotcha... yeah... I need something that I can take apart, clean, replace the apex seals, maybe do a little porting and slap it all back together.
Quote:
Originally Posted by 2gslse
I hope the power of the RE is higher at similar boost as the REW esp. since it will be in a 2500lb car (2540 full street trim now) I think traction WILL be a small problem though
BTW... the engine will have a set of 9.4:1 rotors in it so the low to mid range power should make it really pull hard from 2,000 to wherever peak torque will be.
|
The runners are intake mani yeild themselves to more torque at lower ranges and the flow of the engine seems higher. The 9.4's will definately give it more kick in vac and the lower boost ranges but limit slightly the higherboost. Just keep an eye on the EGT's when tuning and all should be well. Should be a badass setup for sure.... especially in that little lightweight FB. Any traction control or aftermkt diff?
__________________
-The Angry Stig-
DGRR 2009, 2011, 2012 & 2013 - Best FC
DEALS GAP!! WOOHOOOO!!!!!
2015 Audi S4 - Samantha - Zero Brap S4
2004 RX8 - Jocelyn - 196rwhp, 19mpg fuel to noise converter
2000 Jeep Cherokee Sport - Wifey mobile - Now with 2.5" OME lift and 30" BFG AT KO's! So it begins
1998 Jeep Cherokee - 5 spd, 4" lift, 33" BFG's - Rotary Tow Vehicle
1988 'Vert - In progress
1988 FC Coupe - Gretchen -The attention whore BEAST!
I'm a sick individual, what's wrong with you?
I'm pure Evil
I'm still insane, in the best possible way.
I think Brian's idea of romance is using lube.
Your rage caused the meteor strike in Russia. The Antichrist would be proud of his minion.
You win with your thread. Most everything
It's a truck with a steel gate on the back. Just a statement of fact
Motec M820, AIM dash, ported 13B-RE Cosmo, 6-spd trans, 4.3 Torsen, custom twin wg fully divided mani, Custom 4" split into 2x 3" exhaust, Custom HMIC, Custom custom custom custom I like to welder stuff....
No Bolt-ons allowed. Dyno'ed @ Speed1 Tuned by me - 405rwhp on WG.... WM50 cuming soon.
-Angry Motherf*cker Mode ENGAGED-
|