[IH8DSM]

so far the engine ive planned to build is this
-s4 turbo motor ran as a na bridge ported(used housings/irons)
-s5 rotors
-race rotor bearings
-rx8 eshaft
-rx8 front and rear stationary gears
-cryo treated 2mm apex seals atkins
-cryo treated side seals atkins
-solid corner seals
-new apex seal springs, corner seal springs and side seal springs
-aluminum light weight flywheel
-rotating assembly balanced

So with that being said is there anything i should lookout for when it comes to either building/running this motor, should i change or add any parts to the list?