Soooooooooooo let's get back to the last 2 batches of pics I have before I need to do some more work and take some pics.....
So after quite of while of packing up the entire trailer as if I was heading off to the track, I took a length of pipe, suspended it between 2 cinderblocks and found the proper tongue weight, I marked that location and started pulling some measurements off the axle and transferring them to the trailer frame. Then I drilled holes from both the top and the bottom, and took some 3/4" OD .125" wall tubing and cut that to fit. The bolts for the trailer are .5" so they'll fit inside that tube just perfectly. The fear was, as I cranked down on the bolts to mount the axle, the 2" square tubing would deform. So I decided to support it with the round tube installed.
Oh yeah, I had already run the wires for the lights at this point 
All 4 ready to go
Very tight, and very almost ready to be welded.
And finished welded in place. The snake survived and ended up being exactly where it needed to be,
Closeup before I sanded everything down because the bracket needs to be flush mounted
__________________
-The Angry Stig-
DGRR 2009, 2011, 2012 & 2013 - Best FC
DEALS GAP!! WOOHOOOO!!!!!
2015 Audi S4 - Samantha - Zero Brap S4
2004 RX8 - Jocelyn - 196rwhp, 19mpg fuel to noise converter
2000 Jeep Cherokee Sport - Wifey mobile - Now with 2.5" OME lift and 30" BFG AT KO's! So it begins
1998 Jeep Cherokee - 5 spd, 4" lift, 33" BFG's - Rotary Tow Vehicle
1988 'Vert - In progress
1988 FC Coupe - Gretchen -The attention whore BEAST!
I'm a sick individual, what's wrong with you?
I'm pure Evil
I'm still insane, in the best possible way.
I think Brian's idea of romance is using lube.
Your rage caused the meteor strike in Russia. The Antichrist would be proud of his minion.
You win with your thread. Most everything
It's a truck with a steel gate on the back. Just a statement of fact
Motec M820, AIM dash, ported 13B-RE Cosmo, 6-spd trans, 4.3 Torsen, custom twin wg fully divided mani, Custom 4" split into 2x 3" exhaust, Custom HMIC, Custom custom custom custom I like to welder stuff....
No Bolt-ons allowed. Dyno'ed @ Speed1 Tuned by me - 405rwhp on WG.... WM50 cuming soon.
-Angry Motherf*cker Mode ENGAGED-
|