[TitaniumTT]

Originally Posted by FC Zach

The TII spares? Not a bad idea! although I would still worry about the load/ speed rating of the "temporary use only" tires being used on a trailer.

Sooooooooooooooo I figured out how to make the 'vert wheels work... I think... Need to pul one off tomorrow and verify a measurement, but if I'm right, oddly enough it will be an aftermarket Jeep part that makes it possible.... and some new 5x4.5 hubs courtesy of NorthernTool.

Originally Posted by vex

Not to nit pick but I'd put some grommets on your aluminum holes where your wires are traveling through. Having had wires short out in a similar setup it became a pita to try and track down the issue.

Planning on it.... Also need to de-pin the connectors and get some Raychem or that expandable sleeve tubing on the wires.... that shit right there is just sloppy

Originally Posted by ReZ311

Nice. I was also going to suggest an electrical wire plastic cover.

Wait till you see the pass-through's for the 2ga battery cable Wait...... why would someone need 2ga battery cable on a trailer? Ok, maybe 4ga... I need to check my stock to see what I actually have left over.

Originally Posted by Raksj04

I wish I had the tools to weld AL. my Hobart 180 is 1000 miles away. sad face I miss so so much. Living in the barracks sucks.

That blows, I couldn't live without my tools.

Originally Posted by Mazdabater

Some sexy looking welds T. I've always wanted to try ally but you sorta need 3phase power for a decent welder, can't do that in a rental. Then again my stainless skills are still pretty average lol. I'm with you on buying the toolbox though, I thought about making one a while ago. Buying decent rollers costs more then most boxes on the market lol.

Thanks man. I need to get back into practicing TIG welding SS. I was doing alot of really thin shit and it wasn't turning out so good, so I said fuck it and just MIG'ed everything that was SS. BUT, with some future plans that I have, I need to sack-up and get practicing.

Sooooooooo with the exception of a few "finished" photo's withen the next few days, the trailer project will be put on hold for a while as the car needs a little rear end attention before a 2-day track event in 2 weeks. Oh well.... that and I'm waiting on some parts for some sexy finishing touches as I had a few good ideas tonight.