[TitaniumTT]

Originally Posted by MacGyver

Stationary and Rotor bearings:
The engine I'm rebuilding has excellent condition stock bearings but I'm unsure how they will hold up in the long run at elevated power levels.

If there is ever a chance that the bearing is questionable, just buy the RX8 stuff. Cheaper and better than stock replacements.

Originally Posted by MacGyver

Either way I will be using a Racing Beat high pressure regulator

Just find an FD one

Originally Posted by MacGyver

and machining a groove for an o-ring between the pump body and front iron.

Where did you get that idea?

Originally Posted by MacGyver

I'll be keeping the stock ball and spring eshaft jet as well.

Ditch that, get a plug.

Originally Posted by MacGyver

Additionally I (need help with) was thinking RX-8 gears/bearings and Mazdatrix competition rotor bearings

Just go ahead and get the 8 bearings/stat gears if there is any question.

Originally Posted by MacGyver

along with reaming the oil passages to 3/8". Plan is to keep the redline the same. Thoughts on whether is a worthwhile mod or waste of money?

I wouldn't w/the stock pump and the stockish system you have planned.

Originally Posted by NYCGPS

I'm not sure about Groopy and ALS but Mazda seems fine for your Applications.

I wouldn't use them for anything other than stock turbo and 250ish HP

Originally Posted by NYCGPS

No Apex seal can survive too much ping, Groopy might wrap instead of breaking like Mazda, but the result is the same --- you lose compression and you need a rebuild.

BULLSHIT. The seals I run survived a 16.9:1 @ 15psi detonation event... basically cruising @ high rpms, high vacuum and punched it. Boost when from 15" to 15 lbs in a split second and the car detonated so hard it nearly knocked teeth out. Pulled over, pulled a datalog, found the problem, fixed the problem, drove another 1000 miles before doing a compression test.... which showed 114all around

Not to mention... I would much rather have a seal warp and loose compression than break and wipe out a rotor, a housing, possibly a plate and possibly a turbo.... so no, the results are not the same

Originally Posted by NYCGPS

but if your tuning is safe you don't have to worry too much about that in the first place, all you really need to focus on is the tuning.

Things go wrong, and they go wrong faster than you can react. I wouldn't use mazda seals for a hi-hp engine even though plenty of people do.

Originally Posted by NYCGPS

You can use 13B-MSP Eshaft and Bearings, they're better and cheaper. no modification is necessary. As for Rotor bearings, you don't need the compeition one unless you are going above 8-9K rpm all the time, stock actually works quite well

This is accurate and what I run in my engine

Originally Posted by NYCGPS

for oil pressure, you can just use FD rear and add 2 1/8" shims to the front, then you are set, and much cheaper

I wouldn't add the shims. I did in mine and ended up taking them out and my oil pressure is still 135-140 at cold start, and 100psi cruising down the highway. It's just too much.

Originally Posted by infernosg

Good info on the oil pressure regulator - should be cheaper than buying the "upgraded" unit from Racing Beat, etc.

Indeed

Originally Posted by NYCGPS

A note on the RX-8 stationary gears: some modification is required for the rear gear to ensure the oil passage is open and you'll need to use hylomar/silicone to seal the rear gear to the housing as there is no o-ring groove.

Just make sure that it's all lined up when you test fit the gear/bearing assembly. I use a little grey permatex or "right Stuff" in the corner and that's all you really need.

-Brian @ S1