Quote:
Originally Posted by Gregory Casimir
Hey where did you get your din and radio display and how much was it?
|
I picked it up used from another member here. IIRC, they were a limited run part by someone over on 7Club. Unfortunately not something available "off the shelf." It probably wouldn't be all that hard to make if you have some 20 ga steel and the proper tools.
It's starting to looks like a proper engine bay again:
I finished the alternator power wires. They sit higher than I'd like, which means the plug wires are going to be close. Hopefully this won't cause an issue. Starter power, plug wires, and shorten the transmission harness and the wiring is complete.