Rotary Car Club - View Single Post - Twin Charged FD

RX SE7EN · 09-16-2012, 06:45 PM

Getting closer, I need to get a few more clips and then pop them on. Everything is all cut to length now, pretty much done.

Notice how everything is labeled, and on the parts that already have the clip installed, they are completely sealed, you can't see any of the wire sticking out of the back of the clip/connector.

I also doubled up with some heavy duty adhesive lined heat shrink on the raychem boots. I couldn't tell if they were really sealing, but with the extra adhesive heat shrink over the ends, you can see out the adhesive has seeped out, its sealed for sure now.

This connector is for 4 extra injectors. It will remain capped off until i need them.

09-16-2012, 06:45 PM	#204
RX SE7EN Rotary Fanatic Join Date: Feb 2010 Posts: 183 Rep Power: 16	Getting closer, I need to get a few more clips and then pop them on. Everything is all cut to length now, pretty much done. Notice how everything is labeled, and on the parts that already have the clip installed, they are completely sealed, you can't see any of the wire sticking out of the back of the clip/connector. I also doubled up with some heavy duty adhesive lined heat shrink on the raychem boots. I couldn't tell if they were really sealing, but with the extra adhesive heat shrink over the ends, you can see out the adhesive has seeped out, its sealed for sure now. This connector is for 4 extra injectors. It will remain capped off until i need them.