Rotary Car Club - View Single Post - Great, another V8 FC drift car build thread :/

StephenSheppard · 11-12-2012, 07:01 AM

Here's the radiator and fan setup from my 13B that I will recycle for the V8 swap. It holds the temps down on a 13B at 7000rpm+ on 105 degree days for hours on end.......it should be more than enough for the 350. It's one of the last ISC FB radiators modified to fit the FC chassis after I took it out of one of my FBs. Buick Century fan is a pretty serious fan. It cut the fan cycles in half or less (Temp controlled switch via a relay), in comparison to a regular 16" fan. Also the radiator is a double pass which gives the coolant some time to slow down and dissipate heat. I had no such luck with Koyos and stuff like most people run. Also a 22psi cap helps

It's going to need to move forward in the chassis quite a bit judging by Josh my buddies car. Approx. 6-8" forward. It's too tall to stand up right. It would stick about 2-3 inches out of the bottom of the car.

Here's what's hiding under the front bumper. An old repair from a collision with an immovable object while street drifting. That was dumb. I don't street drift anymore because of that lol. I threw this together to get the car drivable at the time.

NOM NOM. That frame rail was way worse. I straightened it with a 12lb sledge hammer a bit lol. I use the term straightened very loosely.

Just terrible.

Out comes the sawzall and the cut off wheel. On a side note my old HF sawzall pulled itself apart and caught on fire while cutting the passenger side frame rail lol. It only made it about 1/2 way through and then destroyed itself. Pretty cool.

Just a little bit of the bent part left. I can work with this now.

What it should look like.

11-12-2012, 07:01 AM	#5
StephenSheppard Rotary Fan in Training Join Date: Nov 2012 Posts: 58 Rep Power: 13	Here's the radiator and fan setup from my 13B that I will recycle for the V8 swap. It holds the temps down on a 13B at 7000rpm+ on 105 degree days for hours on end.......it should be more than enough for the 350. It's one of the last ISC FB radiators modified to fit the FC chassis after I took it out of one of my FBs. Buick Century fan is a pretty serious fan. It cut the fan cycles in half or less (Temp controlled switch via a relay), in comparison to a regular 16" fan. Also the radiator is a double pass which gives the coolant some time to slow down and dissipate heat. I had no such luck with Koyos and stuff like most people run. Also a 22psi cap helps It's going to need to move forward in the chassis quite a bit judging by Josh my buddies car. Approx. 6-8" forward. It's too tall to stand up right. It would stick about 2-3 inches out of the bottom of the car. Here's what's hiding under the front bumper. An old repair from a collision with an immovable object while street drifting. That was dumb. I don't street drift anymore because of that lol. I threw this together to get the car drivable at the time. NOM NOM. That frame rail was way worse. I straightened it with a 12lb sledge hammer a bit lol. I use the term straightened very loosely. Just terrible. Out comes the sawzall and the cut off wheel. On a side note my old HF sawzall pulled itself apart and caught on fire while cutting the passenger side frame rail lol. It only made it about 1/2 way through and then destroyed itself. Pretty cool. Just a little bit of the bent part left. I can work with this now. What it should look like.